The LDG AT-200 ProII Auto antenna tuning unit, Many QRP operators have a small 100-150 watt amplifier for times when you need a few more S-units. The AT-200 is ideal for this kind of operation; its minimum required power is only 5 watts, but it will handle the higher power as well.

The AT-200 will handle up to 250 watts SSB or CW on 1.8 – 30 MHz, and 100 watts on 54 MHz. It features LDG’s state-of-the-art, processor-controlled Switched-L tuner. It will match virtually any kind of coax-fed antenna, including Yagis, dipoles, inverted Vs, slopers, loops, and just about anything. It will typically match a 10:1 SWR down to 1.5:1 in just a few seconds. You can also use the AT-200 with long wires, random wires, and antennas fed with a ladder line with the optional LDG balun.

The AT-200 features over 16,000 3D memories, automatically storing tuning data for frequencies and bands as you use them. When you transmit on or near a frequency you’ve used before, the AT-200 can instantly restore the tuning data. It learns as you use it, adapting itself to your operating patterns for faster and faster tuning. The 3D memory system allows up to eight antenna settings to be stored for each frequency.

The operation couldn’t be simpler: while transmitting a carrier, just press the Tune button. An automatic tuning cycle will begin, then end a few seconds later with the tuner set at the lowest SWR (almost instant for frequencies stored in memory). Optional interface cables for Icom, Kenwood, Yaesu, and Alinco make the entire tuning process a one-button operation.

The AT-200 is the latest in a long line of innovative LDG tuners. Get the most out of your Kenwood, Yaesu, Ten-Tec, or Icom radios that operate at higher power.

5 to 250 watts SSB and CW. (100 watts on 6M)

Easy to read LED bar graph display for RF power, SWR, and status,

16,000 3D memories for instantaneous band changing,

Two-position antenna switch with memories for four antennas on each position,

Tuning time: 0.5 to 6 seconds full tune, < 0.1 second memory tune,

Built-in frequency counter for memory operation,

Frequency coverage: 1.8 to 54.0 MHz,

Tunes 6 to 1000 ohm loads (16 to 150 ohms on 6M), 6 to 4000 ohms with optional 4:1 Balun (LDG RBA 4-1),

For Dipoles, Verticals, Vs, Beams or and Coax Fed Antenna,

Optional external Balun allows tuning of random length, long wire, or ladder line fed antennas,

Optional interfaces for Icom, Alinco, Kenwood, and Yaesu are available,

Power requirements: 11 to 16 volts DC at 750 mA max during tuning,

Enclosure: 8.5 x 6.0 x 2.0 inches,

Weight: 2 pounds.