The SDR-IQ is a 14-bit software defined radio receiver. It offers a broad range of spectrum analyzer and demodulation capabilities. The hardware samples the whole 0.0001-30 MHz band using a high performance, 14 bit analog to digital converter (ADC) running at 66.6 MHz. The digital data from the ADC is processed into I and Q format using a direct digital converter (DDC). The I and Q data is then sent to the PC for processing using a USB 2.0 interface. All of the demodulation and spectral functions are done on the PC side.
The SDR-IQ™ comes with a High Frequency (HF) amplified front-end with switched attenuators, switched filters and 1Hz tuning. The SDR-IQ™ comes with the latest version of Moetronix SpectraVue™ and SDR-Radio software. It supports AM, WFM, USB, LSB, N-FM, DSB and CW with fully adjustable DSP Filter bandwidths and FFT sizes of 2048 to 262144 points. The resolution bandwidth is as low as 0.031 Hz.
High performance HF Receiver with 190 KHz realtime Panoramic Adapter
Ultrasound experimentation (Sonar, Underwater ultrasound, Bat and Insect detectors)
IR (Infrared) subcarrier detection and communications
Record up to 190 KHz of spectrum to hardrive for later playback and demodulation
Panoramic adapter for Communication Receivers (any IF in HF band 455 KHz, 8.83 MHz, 10.7 MHz, 21.4 MHz, etc)
Very Low Frequency (VLF) Studies
Spectrum Analyzer backends
Processor for Radio Astronomy receivers
Smallest SDR with RF DSP™ that samples the whole HF band at once and performs the initial filtering at 67 MHz sample rate with 23 bit accuracy. Uses a high performance Analog Devices 14 bit analog to digital converter.
Sends 16 bits of I/Q Data to the PC via USB. No messy soundcard cables required.
SDR-IQ is USB powered. No power supply is required. Works great with laptops running on batteries.
Incredible receive performance.
High resolution spectrum display with higher resolution and speed than those in $10K radios.
RF preselection filters for great IMD performance.
Serial port to directly interface with radios like the Icom IC-R8500, IC-R9000, IC-R9500, IC R7000, IC-R7100 and AOR AR-5000.
50 ohm RF input that can be easily interfaced to antennas, Ultrasonic transducers, IR detectors, and other RF equipment.
Open source ActiveX control and ActiveX sample program for easy software customization. SpectraVue (not open source).
Windows, Linux and Mac OS drivers for developers.
Network server that allows remoting of the SDR-IQ™. Servers available for both Windows and Linux.
Adds the best panoramic display features to transceivers like the Yaesu FT1000MP MV, FT2000, FT9000 , FTDX5000 and IC-7800 using the RX output connector, RX loopback or IF Output.
Frequency Range: 500Hz to 30 MHz in 1 Hz steps. (Usable down to 100 Hz)
Input Impedance: 50 Ohms
Clipping RF level (Max Gain): -4dBm (Typ)
Maximum Frequency display BW: 190 KHz
Sampling Rate: 66.666 MHz
I/Q Image Rejection: 80 dB+ (Typ)
MDS (500 Hz): -127 dBm @ 14 MHz
Input IP3: 15dBm+ (Typ) * Measured with a dither signal
Voltage: 5 Volts (USB port powered)
Current Draw: 425 mA
Connectors: BNC (RF In), USB 2.0, RS-232 (Serial Bi-directional)
Indicators: Power (Green), Sample (Yellow), ADC Clip (Red)
Dimensions: 3.75x3.75x1.25 Inches
Processor: Atmel AT91SAM7S256 w/ JTAG port.
Analog Demod: AM, WFM, USB, LSB, N-FM, DSB and CW
Measurements Functions: IQ vs. Time, Power vs. Frequency, Power vs. Frequency vs. Time 3D Surface, Power vs. Frequency vs. Time Spectrogram, Power in BW vs. Time, IQ Phase
Max FFT Size: 262144 Point
Max IQ Recording (All BWs): Unlimited to Hardrive.
Screen Update Rate: 50 FFTs/sec , 190 KHz SPAN @ 100 Hz RBW
Window Type: Rectangular, Hanning, Hamming, FlatTop, Blackman, Blackman-Harris
Displayed Average Noise Level dBm/Hz:-133dBm/Hz TYp. 14.200 MHz
Worst Case Spurious Carriers (Birdies):-80dBfs , -100dBfs (typ)
SPAN IQ DATA RATE Min Resolution Bandwidth
5 KHz 8.138 KHz 0.031 Hz
10 KHz 16.276 KHz 0.062 Hz
25 KHz 37.792 KHz 0.14 Hz
50 KHz 55.555 KHz 0.21 Hz
100 KHz 111.111 KHz 0.42 Hz
150 KHz 158.730 KHz 0.61 Hz
190 KHz 196.078 KHz 0.75 Hz
Our Price Match Promise means that if you find any of our Equipment at a lower advertised price elsewhere, we will match the price for you, subject to the below.
- The product is identical to ours in brand, colour, size and model number.
- The price must be the advertised price clearly on the competitor's online site.
- The item must be in stock and available for immediate purchase (rather than available to order), with the authorised stockist able to complete delivery within 2-3 days.
Please fill out the form below. The details will be used to help us with your price promise request.