With its simple USB "Plug and Play" installation, the RIGblaster Data Jack Plug & Play is the simplest RIGblaster to plug in provided that your radio has compatible data/aux jacks. If your radio's data jack allows operation on all bands and modes while supporting proper microphone operation, the RIGblaster Data Jack Plug and Play may be the best RIGblaster for you. Adaptors are required for most radios. See Radio Compatibility Chart for a list of radios that work with the RIGblaster Data Jack Plug & Play, what adapter cables are required, and what optional cables are available.
USB cable, USB powered - No External Power Required, Built-in Rig Control,
Built-in rig control with Icom and Ten-Tec or with TTL level CAT control (round CAT jack) Yaesu radios. Control cable an inexpensive option
Rig control is possible along with sound card PTT control and CW keying on a SINGLE serial port using Hamscope or MixW software. If HRD is used with DM780, because they are separate programs, they must be configured correctly to work together as one program
True Keyed CW
Fully isolated CW keying output for direct keying of your rig's CW. This jack is for use with non-sound card software using serial DTR control. CW Keying cable optional
Simplest radio to plug in provided your radio has compatible data/aux jacks
Available adapters simplify mic/keyer/audio connections
Isolated Audio and Keying
Front panel indicators show PTT and CW keying control, USB connection status
Properly matched and RF suppressed audio for your radio
Carrier detect (COR) for Echolink Ready (see Support Page for detail on activating this feature)
Compact - great for portable or QRP operation
Assembled in the USA to IPC-610 manufacturing standards
The printed circuit board uses FR4 material, double-sided, plated through holes, solder mask over bare copper, silk-screened
Stainless steel hardware throughout including PEM™ threaded mounting standoffs
Specifications, See The Radio Compatibility Chart for a list of radios that work with the RIGblaster Data Jack Plug & Play, what adapter cables are required, and what optional cables are available.
Overall Dimensions (maximum, w/o cables) .65" H x 2.9" W x 2" D
Weight (with cables) 2 oz.
DC Power requirements 5 V USB powered < 60mA
Frequency response sound card input 100 Hz - 15 kHz, + - 1dB
Distortion sound card input Less than 0.1 % THD @ 1kHz
Input impedance (from sound card) 600 ohms resistive, minimum
Sound card level -20 dB
PTT max rating 10 mA @ 8 V
USB interface USB 2.0 or lower,
The line-level (data jack) audio is completely isolated from all other grounds. The sound card audio is isolated using two audio isolation transformers for both transmit and receive. The PTT and CW keying circuits are fully isolated using a dual optoisolator.
Unlike the RIGblaster Pro, Plus II, and Plus the RIGblaster Data Jack Plug & Play was designed for specific radios and as such will only work with specific radios.
Includes: RIGblaster Data Jack Plug & Play
•CD-ROM with Device Drivers, Owner's Manual & WMR Collection of Ham Radio Sound Card Software.