Capabilities, Operate your favorite digital mode program simultaneously with your favorite logging program
Software configuration of most options with included DXpro application
Fully compatible with RemoteHams/HRD for remote control of your station
Switchable 12V DC output for remotely controlling a small station accessory such as a TNC or 12V relay
The onboard header for optional CLRmod DSP gives you fully adjustable Clearspeech® audio when using the DXpro remotely
Integrated sequencer ports for high power VHF/UHF safety
Hardware squelch input for EchoLink® or other applications
Powered via USB or external 12V (with software switchable 12V output jack)
External pass-through USB jack for convenience
Precision engineered in the USA with extensive RF filtering
Dual high-performance sound cards allow simultaneous monitoring of main and sub receivers. Run digital mode programs on each channel. Perfect for SO2V/SO2R.
Easily configure the RIGblaster DXpro for most radios with pre-wired jumper blocks (ISC)
Seven ISCs included. Covers most Icom, Yaesu, Kenwood, Elecraft & Alnico radios.
Built-in Rig Control
Independent fully implemented CAT with optional inversion. TTL & RS232 outputs.
Record voice keying wave files using your radio's own microphone. Also allows you to record both sides of your QSO.
Multi-tap footswitch input (or analog keypad) provides up to three trigger signals for contest voice keying
Integrated Fldigi "right-channel" RTTY detector turns AFSK into FSK, even on Mac OS or Linux. A similar feature turns tone Morse Code into true keyed CW.
Front panel mounted transmit and receive audio level knobs makes it easy to adjust transmit/receive levels on the fly without having to make changes in software sound levels,
Three-position switch for PTT selection,
4 onboard transformers for complete audio isolation,
Mechanical relay for PTT. Works with classic or modern rigs.
Overall Dimensions (maximum w/o cables) 1.31" H x 9.97" W x 3.87" D
Weight 19.2 oz.
DC Power Requirements USB Powered
PTT Max Contact Rating 2A @ 24V or 1A @ 48V
CW/FSK Direct Keying Ratings Transistor logic only, tube rigs not supported. Positive pull-down 20mA max.
Serial Interface Port USB,
TTL CAT (dual circuit mini-jack connector) Standard/Inverted TTL 5V logic, selectable bi-directional or unidirectional
RS232 CAT (DB9 male) Fully independent, all control signals present including hardware flow control
Sequencer Start Port (Output, RCA female) Transistor logic only. Open collector output, max: 20mA / +40V.
Sequencer End Port (Input, RCA female) Transistor logic only. Internal pull-up to +5V.
The microphone audio is completely isolated from all other grounds.
The PTT relay provides adequate current and voltage capability to switch tube rigs.
Includes, RIGblaster DXpro Unit
(1) 1/8" Audio Cables, 6 ft.
(1) 8-pin Screw-on Custom Mic Cable, 3 ft
(1) RIGblaster 12V DC Cord with Powerpole®, 6ft.
Instant Setup Connectors,
DVD with Device Drivers, Owner's Manual & Collection of Ham Radio Sound Card Software,
(8) White Jumpers,
(5) Blue Shunt Jumpers,
A DVD of the RIGblaster Software Collection is the standard media. If you are unable to use DVD media, you may request the software on a three (3) CD Set. When ordering online, in the comments section of the order form, type in "Request 3 CD Set". Alternately, the collection of software programs may be individually downloaded here.
The owner's manual is available in PDF format on the DVD and online. If you require a printed manual, request "Printed Manual" in the Notes section of the online order.