MFJ-1664 6-80 Meters Portable Screwdriver Antenna 6-80 meters using a supplied whip 10 feet in length.

The MFJ-1664 manually tuned screwdriver antenna was designed for continuous operation from

6-80 meters using a supplied whip 10 feet in length. The supplied 4 ½ foot whip can be used for

mobile or limited space operation from 6-40 meters.

The antenna is tuned by loosening a thumbscrew and moving the aluminum cover up or down the

loading coil. The loading coil is made of tin-plated copper wire wound onto a PVC pipe core.

Copper Beryllium finger-stock is used to make the connection between the aluminum cover and

the loading coil. Portable Operation And Mounting,

The MFJ-1664 becomes a very efficient portable antenna when used in combination with a tripod,

and a ground radial system. The antenna can be easily mounted onto a tripod such as the MFJ1918 or similar mount for portable, operations. The MFJ-342 3/8 pipe mount easily attaches the antenna to a tripod. The antenna must be properly connected to a ground radial system.

Portable Setup,

1. Remove the antenna from the packaging.

2. Place a 3/8“ lock washer onto the 3/8 X 24 thread of the desired whip.

3. Carefully screw the desired whip into the 3/8 coupling nut located on top of the loading coil.

4. Secure the whip in place with a 9/16 wrench.

5. Place a 3/8” lock washer onto the 3/8 X 24 mount on the base of the loading coil.

6. Screw the antenna into the desired mount 3/8 X 24 female mount such as the MFJ-342.

7. Secure the antenna in place using a 9/16” wrench.

8. Attach the counterpoise system to the ground shield of the feed-line. If using an MFJ-342

or similar mount attaches the ground radials to one of the ¼” bolts located on the mount.

Check to make sure the ground system does not come into contact with the screwdriver,

Mobile Setup,

1. Remove the antenna from the packaging.

2. Place a 3/8“ lock washer onto the 3/8 X 24 thread of the desired whip. ALWAYS USE

LOCK WASHERS FOR MOBILE INSTALLATIONS.

3. Carefully screw the desired whip into the 3/8 coupling nut located on top of the loading coil.

4. Secure the whip in place with a 9/16 wrench.

5. Place a 3/8” lock washer onto the 3/8 X 24 mount on the base of the loading coil.

ALWAYS USE LOCK WASHERS FOR MOBILE INSTALLATIONS.

6. Screw the antenna into the desired amount.

7. Secure the antenna in place using a 9/16” wrench.

8. Attach a vehicle ground to the ground shield of the feed-line. The ground should be

attached directly to the vehicle frame or body. Check to make sure the ground system

does not come into contact with the screwdriver antenna. 

WARNING: SERIOUS RF BURNS AND INJURY CAN OCCUR IF CONTACT IS MADE WITH THE ANTENNA. PLACE THE ANTENNA IN AN OUT OF REACH LOCATION.